Turn the knob clockwise a quarter turn to add some space between the gate and the card. If proof of purchase or product registration cannot be established, shipment date to the original buyer dealer or distributor will be used to establish the warranty period. Indicates that except for card and ribbon loading and maintenance, the cover must remain closed. Ih Command – Print Hologram W Command – Change Encoding Direction A card containing small oxide particles physically oriented into zones of varying widths. The material on which the magnetic stripe is deposited.
|Date Added:||28 February 2016|
|File Size:||43.20 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
A Privilege card printer prints on standard credit card size cards.
The screen that appears when the program starts has flags for several nations and a small button at the lower-left corner. No amount of cleaning can remove dye or resin fused onto delicate Print Head elements. A 89 Appendix C The Color Correction tab has sliders that allows color adjustments for red, green, and blue both intensity and contrast. Often, only black resin say for a bar code gets applied on the second side.
Personal Identification Number, encrypted in the magnetic stripe encoding on a financial card. Color Ribbon – Press and hold the Panel Button until ribbon advances. Take extra care when installing a Print Station ribbon.
Data downloading is the only difference between a P with Expanded Memory and one without. Card Handling Process These settings allow the advanced users to control color and image clarity. Secure employee identification badges Access control etlron National ID cards drivers license, health care cards All Eltron card printers are built to tough ISO standards.
A Glossary ISO: For Step 1 Lamination ribbons, the notched end of the empty core must face up. Neglect in performing recommended cleaning procedures can void your warranty, as can improper packaging and shipping.
Eltron P dual-sided id card printer with lamination
All Eltron card printers are built to tough ISO standards. Other than the recommended cleaning procedures described in this manual, only allow Eltron factory authorized technicians to service these printers NEVER loosen, tighten, adjust, bend, etc.
P Runs Stepper 2 sec. Expanded Memory Board Installation. The upper Laminator roller generates a substantial amount of heat with power switched on. Figure Ribbon Preparation 20 Rev.
Solvusoft: Microsoft Gold Certified Company
Measured quanti- ties of black dye diffuse from the ribbon onto the eltrno on a dot-by-dot basis. Check boxes enable or disable duplex printing, data compression, and a preview of the image awaiting printing.
Other than the recommended cleaning procedures described in this manual, only allow Eltron factory authorized technicians to service these printers.
However, check the configuration to determine whether the magnetic stripe should face up or face down. Tc Command – Set Temperature A 77 Appendix C This produces first a screen that allows confirmation of driver installation. Eltron Product Catalog Page – 67 K. Note that two screws hold Rollers each Shroud in place. With confirmation, a screen then appears that allows the installation of either 5p00 network or local printer. Any bit map imported should be black and white, where black prescribes varnish and white prescribes no varnish.
Ribbon Loading Using a prepared ribbon, unroll a comfortable Step 3 amount from the supply side to span the dis- tance between the Supply and Take Up spindles. If more than one card feeds, a card jam occurs.
Personal injury could result. DeStep 4 pending on the setup, use one of the following: Notably, only dye sublimation images require this protection.